Watermark profiles allow you to save custom watermark settings as templates that can be used again later to add watermarks to documents. There is also an option available to "Show on Menu" and when this is set for the profile it will be put under Pages Tab > Watermarks so that the profile can be run in just two clicks from the document menu.
Note: You do not need to create or save a watermark configuration before adding a watermark to a document. To add a watermark to a document without saving settings just go to Pages Tab > Watermark > Add and choose the settings to use and click Apply to run the watermark settings without saving a profile.
There are 2 ways to apply an existing watermark profile:
Open the document that you would like to apply a watermark to. Open the Watermark dialog from Pages Tab > Watermark > Add. Choose the watermark from the drop down list in the combo box, click on the Apply button at the bottom of the dialog.
Open the document that you would like to add a watermark to. Under the Pages Tab > Watermark menu, there is a list of all the watermark profiles that you have previously created. Click on the watermark profile in the list you'd like to run and it will begin immediately using the settings saved in the watermark profile.
Note: Only the ones for which you chose the Show on Menu option will appear on this list. Click on the watermark profile in the list you'd like to run and it will begin immediately using the settings saved in the watermark profile.